Topcon Office Ideas

Hi Barkley,

Just tested this with v6.0 and the contours only update when the option is cancelled. See attached video.

Regards,
David Banks
Geospatial Sales Consultant

Position Partners Pty Ltd (ACN 1303 67 065)

A: 92 Wetherill St Nth, Silverwater, NSW, 2128
O: +61 2 9714 0000 |
D: +61 2 9714 0090 |
M: +61 409 051 471 |
F: +61 2 9714 0099

www.positionpartners.com.au
Sales, Hire, Service & Training
Geospatial & Positioning Solutions for Construction,
Surveying, Mining and Building

This E-mail (which includes any attachments) is confidential and may contain sensitive information. It is copyright and may be read, copied and used only by the intended recipient(s). If you have received it in error please contact the sender immediately by return e-mail. Please then delete the e-mail and do not disclose the contents to any other person. There is no warranty that this email is accurate, complete, error or virus free, and no liability is accepted. Any views expressed are those of the sender and do not represent the views of Position Partners, unless stated otherwise

Hi Barkley, attached is a short video showing how the "Swap Triangles" behaves currently and once you have selected the two triangles to swap, you have to Cancel to update Contours.

Further to the above, if you were comparing two surfaces and could real time compare the area/volume between them while dynamically altering the DTM's whether that be swapping, adding, deleting, breaklines etc in the DTM like a modeless methodology...